Surface Treatments
Certifications
- ISO 9001:2015
- NORSOK M-650
- NACE MR0175
- ISO 15156-3
- PED 2014/68/EC
- EN 10204 type 3.2
- AD 2000 W2/W7/W10
Ferralium 255 Sheet (UNS S32550)
Cold-rolled sheet 0.5 to 6 mm to ASTM A240 / EN 10088-2, 2B / 2D / BA finish for forming, gasket, and lining service
Sheet (≤ 6 mm) and plate (> 6 mm) split the flat-rolled product range at the rolling-mill boundary: sheet is cold-rolled with a controlled surface finish, plate is hot-rolled with a descaled mill surface. Ferralium 255 (UNS S32550, EN 1.4507) sheet is the right pick for formed components, vessel linings, gasket and shim stock, and any application requiring a 2B, 2D, or BA mirror finish. The cold-rolled super duplex sheet retains the wrought ferrite-austenite microstructure of the heavier plate but with tighter dimensional tolerance and a defined surface finish. Per-heat EN 10204 type 3.2 MTC, ferrite content within 35 to 55%. RFQ: info@torqbolt.com / WhatsApp +91-22-66157017.
Sheet Size and Finish
| Thickness | Width | Length | Finish (EN 10088-2) |
|---|---|---|---|
| 0.5 mm to 1.5 mm | 1000 to 1250 mm | 2000, 2500 mm or coil | 2B (cold-rolled, mill annealed, lightly cold-rolled) |
| 1.5 mm to 3 mm | 1000 to 1500 mm | 2000, 2500, 3000 mm | 2B or 2D (annealed, descaled) |
| 3 mm to 6 mm | 1000 to 2000 mm | up to 6 m | 2B or 2D |
| 0.5 mm to 6 mm | per drawing | per drawing | BA (bright annealed, mirror) |
Formability and Bend Limits
Super duplex sheet is harder to form than austenitic 304 / 316 because the higher yield strength means greater spring-back and the duplex microstructure has limited ductility above 5 percent strain before re-solution annealing is required. Practical bend limits for Ferralium 255 sheet at room temperature: minimum bend radius 2 × thickness for transverse-direction bends, 3 × thickness for longitudinal-direction bends. Forming above 5 percent strain (deep draws, severe bends, beading) requires intermediate annealing at 1080 °C with water quench to restore ferrite balance. For thin-gauge formed components specify the 2B finish; for chemical vessel linings and decorative service specify BA.
Related Products
- Ferralium 255 plate per ASTM A240 (> 6 mm)
- Ferralium 255 flat bar
- Ferralium 255 tube per ASTM A789 (welded sheet-derived tube)
- Ferralium 255 welding procedure
Satisfaction Survey
