Surface Treatments
Certifications
- ISO 9001:2015
- NORSOK M-650
- NACE MR0175
- ISO 15156-3
- PED 2014/68/EC
- EN 10204 type 3.2
- AD 2000 W2/W7/W10
Ferralium 255 Flat Bar (UNS S32550)
Hot-rolled and cold-finished rectangular bar per ASTM A479 / A276 for fabrication, machining, and structural service
Flat bar is the workhorse rectangular section that fabricators reach for when they need a custom-thickness raw stock between sheet (≤ 6 mm) and plate (≥ 6 mm). Common downstream operations are CNC machining of valve spool components, water-jet profiling of pipe support clamps, plasma-cut tube-sheet baffles, and laser-cut gaskets and shim stock. Ferralium 255 (UNS S32550, EN 1.4507) flat bar covers the same compositional and mechanical envelope as the round and forged bar product, supplied solution-annealed at 1080 °C and water-quenched to land ferrite content within the 35 to 55% qualifying band per ASTM E562. Per-heat EN 10204 type 3.2 MTC with chemistry, mechanicals, hardness traverse, ferrite point count, and PREN calculation. RFQ: info@torqbolt.com / WhatsApp +91-22-66157017.
Flat Bar Size Range
| Form | Thickness | Width | Length |
|---|---|---|---|
| Hot-rolled flat bar | 6 mm to 100 mm | 20 mm to 500 mm | up to 6 m |
| Cold-finished flat bar | 3 mm to 50 mm | 10 mm to 300 mm | up to 6 m |
| Strip / coil-derived flat | 1 mm to 6 mm | 20 mm to 500 mm | cut to length |
| Custom rectangular | per drawing | per drawing | per drawing |
Controlling Standards
ASTM A479 / A479M (Stainless Steel Bars and Shapes for Pressure Vessels) is the umbrella spec for super duplex bar in pressure-vessel and ASME B31 piping service. ASTM A276 / A276M (Stainless Steel Bars and Shapes) covers general-service flat bar where pressure-containing duty is not the primary use case. EN 10088-3 (European equivalent) covers metric flat bar to the same compositional limits with the EN 1.4507 grade designation. For NACE MR0175 / ISO 15156-3 sour-service the heat must satisfy hardness ≤ 32 HRC, ferrite 35 to 55%, and PREN ≥ 40 calculated from the actual heat composition.
Common Downstream Use
- Valve internal components (gate, seat, wedge) machined from rectangular stock
- Pipe support clamps and saddles, water-jet or laser cut from flat plate
- Heat-exchanger tube-sheet baffles and partition plates
- Gasket / spacer / shim stock for pump and compressor service
- Structural reinforcement straps, lifting eyes (forged from flat bar billet)
Related Products
- Ferralium 255 round bar per ASTM A479
- Ferralium 255 plate per ASTM A240 (≥ 6 mm)
- Ferralium 255 sheet per ASTM A240 (≤ 6 mm)
- Ferralium 255 square bar
- Ferralium 255 hex bar
Satisfaction Survey
